Tremec has built a working manual-transmission version of the mid-engine Chevrolet Corvette C8, and the company let a reporter, along with several potential customers, drive it at a private test track outside Howell, Michigan, called Motorsports Gateway. The car is a one-off prepared by Peitz Performance as a race car around Tremec's new transaxle, and it is real despite rumors to the contrary. Tremec used the event to sample its entire transmission line at the facility, which is new enough that it does not yet appear in online maps.
The C8 was the first Corvette to place its engine behind the driver, and the first sold only with a dual-clutch automatic. According to the account, GM weighed the cost of developing two new transaxles, one manual and one automatic, and put its money behind the automatic, a decision that helped the car in comparison testing but left enthusiasts without a third pedal.
Why the conversion is less radical than it sounds
Peitz did not have to re-engineer the car around the gearbox. The tunnel was cut to fit the clutch pedal hardware, but the manual transaxle mounts where the production dual-clutch unit sits, with no special mating parts required. The pedal box, per the reviewer, has ample room for a clutch and still feels roomier than a previous-generation Camaro's.
The shifter sits where the cabin's storage cubby and automatic selector normally live. Because the gearbox is at the rear, the lever is remotely mounted and works through cables running aft, a layout that makes it feel different from the front-engine TR-6060 six-speed Tremec supplies to GM performance cars including the Blackwing sedans and the discontinued Camaro. The remote linkage is slightly less precise and less notchy, smoothing off some of the Tremec's rougher edges; drivers who prize mechanical feel may miss the direct-mounted version. The only fixes would be moving the engine forward, which yields a C7, or moving the shifter rearward, which would put the driver's seat roughly where the C8's engine is mounted.
A race-car cockpit and a tight fit
The development car is a full track build: essentially no interior finish, a welded cage and a racing harness. Seat adjustment is all but absent, which suited its regular driver but not the 5-foot-7-inch reviewer, who could not reach the pedals cleanly enough for heel-and-toe work. That limitation, plus a green track on a November afternoon in Michigan, kept the test conservative, and the handover instructions were simply to avoid hitting anything.
Cost remains the obstacle
The gearbox alone is quoted at about $75,000, and combined with the price of a Corvette the build rivals a showroom-spec Z06. Tremec says that figure will come down as volume rises and that OEMs have shown interest, not necessarily and certainly not exclusively GM. The unit was engineered to fit the C8, but other automakers are reportedly looking for a high-torque manual transaxle. Whether a manual returns to the Corvette line therefore depends less on engineering feasibility than on the business case.
