KraussMaffei Extrusion has introduced a single-stage extrusion process for PVC roofing membranes that removes the separate mixing step used in conventional dryblend production. The Laatzen-based machinery supplier announced the system, called PVC InlineMixing, on 17 November 2026 as a continuous alternative to the established two-stage route, citing lower energy consumption, shorter production times and a correspondingly faster return on investment.
The conventional two-stage route
In the standard sequence, PVC powder is combined with plasticizers, additives and fillers and processed batchwise in a hot-cold mixer combination to create a dryblend. That compound is cooled, held as an intermediate product and later plasticized in a twin-screw extruder before being formed into membrane. Each of those steps brings its own equipment, floor space and energy demand.
Direct dosing into the extruder
Under the InlineMixing concept, all solid and liquid components are metered straight into the extruder through gravimetric dosing systems in the proportions the formulation calls for. Because no separate heating-cooling-mixing combination is involved, the material is heated only once. KraussMaffei states that energy consumption, and therefore energy cost, falls by up to 75 percent, with the actual figure depending on the formulation, the system parameters and the plant location.
The company also points to lower capital expenditure, since no separate mixing installation has to be bought, and to reduced operating costs: less floor space is needed, fewer staff are required than on a line using dryblend premixing, and maintenance is lighter because wear parts for the heating-cooling mixer are no longer part of the process.
Formulation changes during operation
A further stated benefit concerns changeover. Formula adjustments and colour changes can be carried out during running production through the integrated control system, according to the supplier, which removes the preparation and interim storage of separate dryblend batches. Christopher Bartel, Head of Sales Flat & Foam at KraussMaffei Extrusion, described the advantage in competitive terms: membrane manufacturers gain lower production costs, greater flexibility and more efficient manufacturing, can respond faster to new requirements, and can adjust formulations directly in the running process while cutting energy and capital expenditure.
Trials and extruder platform
The process was developed at the company's Extrusion Technology Center in Laatzen and validated with industrial roofing membrane formulations. The trials used a co-rotating twin-screw extruder from the ZE 65 BluePower series, equipped with loss-in-weight feeders for all solid components and multiple liquid feeders for free-flowing ingredients. The series has a Da/Di ratio of 1.65; the combination of high torque and large free volume is intended to provide a wide process window for processing different formulations. KraussMaffei reports that the tests achieved good gelation of the PVC and high product quality, and that mechanical properties and weldability of the membranes met industrial requirements across several formulations.
Industrial reference installation
PVC InlineMixing is already in use in an industrial production line for PVC roofing membranes. That reference plant reaches a total throughput of 1,800 kg/h with two extruders and two calenders, processing PVC, additives and fillers together with the resulting edge trimmings continuously into finished membrane. Bartel said the results demonstrate the potential of the process for industrial membrane production, and that customers can test their own formulations under production-relevant conditions at the Technology Center.
