Zeph Gage has developed a rear-only portal axle for an XJ Jeep by turning the rear differential upside down and combining a Ford 9-inch axle housing with Humvee hardware. The project is notable for its cost: the article says a typical set of portal axles from companies such as 74Weld runs about $20,000, while the unit on Gage's Jeep costs roughly one-fifth of that.
Portal axles place a gear stack behind each driven wheel rather than letting axle shafts and other components hang below the transmission and transfer case. That arrangement lets the axle shafts sit higher and reduces hardware below the frame, allowing taller tires and more ground clearance. The tradeoff is usually price and complexity, which is what makes Gage's rear-only approach stand out.
A flipped differential and Humvee hubs
Gage's assembly uses a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals of the Humvee type reverse the rotation of the input shaft, so Gage flipped the differential upside down to make the driveline spin in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, in effect creating a high-pinion unit from low-pinion parts that have been inverted.
The conversion is described as adding about six inches of clearance. It also preserves full shock travel, a difficult goal with portal axles, and reduces stress on the differential itself. The article describes the resulting setup as effectively bulletproof, though that is an assessment rather than a tested guarantee.
Why only the rear axle
Installing a portal axle at the rear without matching it at the front is a common trick in the remote-control rock crawler scene. By keeping the front solid axle, Gage avoids the packaging constraints that can arise when portal axles are fitted to a vehicle that never had them from the factory. He also does not have to limit shock travel because of those constraints, and the ride height does not rise to an extreme level. The article describes the result as a best-of-both-worlds solution.
This is not an off-the-shelf kit. Gage carried out substantial custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it has an integrated electric emergency brake solenoid and because it helps with clearance.
The finished XJ can drive over a five-gallon bucket and still have several inches of spare clearance, according to the article. That means the rear end is less likely to hang up on obstacles that the front end can steer around. A video from Outdoor Auto covers additional details, including how Gage matched the gearing front and rear. The project shows how a rear-only portal setup can cut cost and packaging work, but it also makes clear that the result depends on fabrication and parts selection rather than a simple bolt-on conversion.
